no nevim jak to mas ty, ale me tam ty kody zustavaji proste dokud je nevymazu. preci kdyz se ti neco podela nekde cestou, tak nemusis vyblikavat zavady do 10 minut, to by bylo naprosto k nicemu.Mis.us píše:spoj černý konektory jak ty řikáš..."paměťový svazek"-pamětový svazek to je,ale chyby se ukládají jen na dobu určitou!cca 5 až 10 minut,potom co si zhasnul motor,když začal při jízdě svítit check,po 10ti minutách check bliká nepřetržitě a ne závadu!
abychom si teda rozumneli, pri normalnim provozu check engine po oprave samozrejme svitit nebude, ale kdyz zacnes snovu vyblikavat pamet, mel by tam ten kdo byt stale, pokud si ho nevymazal.
tohle jsem nejak minul, kde konkretne je to napsany?Mis.us píše:Hlavně v tý příručce co posílal artvandal odkazem je napsáno,že se startovat nesmí,pokud jsou konektory spojeny!
co tam je v sekci test modes:
With neither test connector connected and the key ON(not running), the codes will display codes related to starting and driving. -> zadny konektor spojen (melo by ukazovat kody spojene se startovanim a rizenim? to mi trochu unika...)
With only the "Read Memory" connector connected, historic codes will be displayed. -> spojene cerne konektory ukazuji historicke kody z pameti
With only the "Test Mode" connector connected, a technician can perform dynamic tests. -> spojene zelene konektory jsou rpo zobrazeni aktualni zavady (dynamicky test)
The last mode is for clearing codes.(See Clearing Codes) -> posledni moznost, spojit oba konektory, tim se vymazava pamet historickych kodu
clearing codes:
Codes will only clear when the faulty system or circuit has been repaired. After making the repairs, codes can be cleared by connecting 2 pairs of connectors, the "Self-diagnostic" connectors and the "Read Memory" connectors that are usually to the right of the diagnostic connectors. -> Kody z pameti mohou byt vymazany jen kdyz je zavada odstranena. Po oprave, kody mohou byt vymazany spojenim dvou paru konektoru (chapu to tak ze zelene a cerne) . posutp je hned pod tim:
1 Start with a warmed up engine -> zahrat motor
2 Turn off the engine -> vypnout motor
3 Connect both pairs of connectors-> spojit oba konektory
4 Fianlly start the engine -> nastartovat
5 This should clear the codes. ->kody by mely byt vymazany